Saving/Calling Up A Program - Hanil M15S User Manual

4. Operation
4.6 Short Run
The[Short]buttonisforwhenpress&hold,toaccelerateuptomaximumspeedanddeceleratewhenthe
buttonisnotpressed.
1. Set the desired run speed. [ Refer to. 4.2 Setting RPM/RCF]
2. Press the Short button more than 2 sec.
▶ While pressing [Short], the equipment will accelerate up to maximum RPM.
▶ By stop pressing the [Short], the equipment will decelerate to stop.

4.7 Saving/Calling up a Program

[Saving]
1. Set the RPM(or RCF) / Run time / Accel, Decel rate
2. Press the Left of Right button until Prog display flashes(0).
▶ You can save 10(0~9) programs.
3. Press Up or Down button until the required program number is displayed.
4. Press the Enter button.
[Calling up]
1. Press the Setup/Enter button.
2. Press the Left of Right button until Prog display flashes(0).
3. Press Up or Down button until the required program number is displayed.
4. Press the Enter button.
www.ihanil.com
16/22