RGBlink X3 User Manual page 35

Layer
Layer number ： Numbers in the corner is to show
how many layers at present allowed to put in the
output.
The number in the red rectangle on the right figure
represents the number of layers that can be placed at
the output.
Note：One signal occupies one layer (4K signal occupies four layers), signal can be dragged into the container
repeatedly.
Layer Adjustment
There are two ways to adjust layer.
1. Use the bar under the interface
Choose one layer and the bar shows its signal source,
type in position and size. Click Set to confirm.
2. Layer Scale and Crop
Choose one layer needed to be adjusted.
this icon means data related, when width is changed,
height will be changed as same proportion.
this icon means data not related, width and height
need to be filled respectively.
X3 User Manual
34