Advertisement
Available languages
Available languages
V1.0
2.
Always begin by cutting the top of the pipe
(Fig. 18-1).
3.
From there, move to the side and cut
downwards (Fig. 18-2).
4.
Move to the final side and cut the remaining
section of pipe (Fig. 18-3).
Thinner workpieces, such as sheet
metal, should be cut using solely a
forward motion for greater control
(Fig. 19).
WARNING! Always ensure the tool is switched off
before performing any inspections or maintenance.
1.
Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged
or worn components. Only use identical replacement parts when
servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool clean, dry and free from oil/grease at all times.
6.
Check the tightness of all fasteners.
7.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should
repair the tool. An improperly repaired tool may
present a hazard to the user and/or others.
If using an abrasive blade with this tool, be sure to
perform checks before every operation for cracks
(Fig. 20). If damage is found, replace.
Visit www.princessauto.com for more information
14 in. 74cc Gas Cut-Off Saw
9096553
Fig. 18
Fig. 19
Fig. 20
17
Advertisement
