Advertisement
Available languages
Available languages
9096553
NOTICE! Do not use different
dimensions of flange washers.
1.
Check that the threads on the spindle shaft are
undamaged.
2.
Check that the contact surfaces on the blade
and on the flange washers are undamaged, of
the correct dimension and clean
3.
Ensure that the flange washers run properly on the spindle
shaft (Fig. 5).
This tool is supplied with either a bushing that can be flipped over to fit
blades with either a 20 mm centre holes or with a fixed 20 mm bushing. A
decal on the blade guard indicates which bushing has been factory fitted.
1.
Check that the bushing on the machine's spindle shaft corresponds
with the centre hole of the cutting blade. The blades are marked with
the diameter of the centre hole.
WARNING! Never use a cutting blade for any other
material than it was intended.
WARNING! Never use a cutting blade with a lower
speed rating than the tool (see Specifications).
WARNING! This tool is not for use with carbide-
tipped, toothed blades.
High-quality cutting blades are recommended for use with this tool.
Always ensure that the right bushing is used for the cutting blade being
fitted to the tool.
Different blades have different requirements surrounding cooling and
whether or not they are to be used for wet or dry cutting. Always refer to
a blade's specifications before using.
Always choose the correct blade for the operation and/or workpiece.
12
14 in. 74cc Gas Cut-Off Saw
For technical questions call 1-800-665-8685
V1.0
Fig. 5
Advertisement
