Advertisement
Available languages
Available languages
9096553
1.
Make sure that the stop switch is in the correct position.
2.
Set the choke control in the choke position, which is also the
automatic start position.
3.
Depress the decompression valve.
4.
Push the choke control to disable the choke.
5.
Grip the front handle with your left hand.
6.
Put your right foot on the lower section of the rear handle.
7.
Pull the starter handle with your right hand until the engine starts.
7.1 Do not twist the starter cord around your hand.
7.2 Do not pull starter cord all the way out.
7.3 Do not let go of starter cord when fully extended, allowing it to
snap back aggressively. This can damage the tool.
8.
Press the throttle trigger to disengage the
start throttle and let the tool idle.
1.
Holding the saw firmly with both hands,
position yourself responsibly at your
workpiece.
2.
Press the trigger and allow the tool to reach
full throttle.
3.
Apply the cutting blade to the workpiece
using gentle downward force.
4.
Carefully move the blade forwards and backwards until the desired
results are achieved.
4.1 Do not skew or twist the blade
within the cut (Fig. 16).
5.
Release the trigger and allow the tool
to come to a complete stop before
assessing workpiece or moving tool.
1.
Ensure the pipe is properly supported and secure (Fig. 17).
16
14 in. 74cc Gas Cut-Off Saw
For technical questions call 1-800-665-8685
V1.0
Fig. 16
Fig. 17
Advertisement
