Safety Measures (See Section 3); Tools And Spare Parts Supplied With Machine; Maintenance Operations - Recommended Inspections/Frequency; Inspections Performed Before/After Every Maintenance Operation - 3M -Matic 7000a Pro Instructions And Parts List

13. Maintenance and Repairs

13.1 Safety Measures (see section 3)

13.2 Tools and Spare Parts Supplied
13.3 Recommended Frequency of Inspection and Maintenance Operations
Operation
Inspection safety features
Cleaning of machine
Cleaning of cutter blade
Oiling of felt pad
Lubrication
Blade replacement
Drive belt replacement
13.4 Inspections to be Performed
13.5 Check E ciency of Safety
13.6 Cleaning of Machine
3M-Matic ™ 7000a-7000a3 Pro
Page 31
Carrying out maintenance and
repairs may imply the necessity to
work in dangerous situations.
with the Machine
See Spare Parts Order Section.
Before and after every
Maintenance Operation
Before every maintenance operation,
Turn the main switch OFF (O) and
disconnect. During the maintenance
operation, only properly trained and
quali ed personnel must work on
the machine. At the end of every
maintenance operation check the
safety devices.
Features
1. Blade guard assembly upper
taping head
2. Blade guard assembly lower
taping head
3. Latching Emergency stop button
with mechanical lock (interrupt
supply of electrical power)
4. Turn main switch STOP/OFF (O)
5. Safety guards top drive belts
Quali cation 1
A weekly cleaning with dry rags or
diluted detergents is necessary.
Cardboard boxes produce a
signi cant quantity of dust and
paper chips when processed or
handled in case sealing equipment.
If this dust is allowed to build up on
machine components, it can cause
Frequency
daily
weekly
weekly
weekly
monthly
when worn
when worn
13.7 Cleaning of Cutter Blade
• To reduce the risk associated with
mechanical and electrical hazards:
Read, understand, and follow all safety
and operating instructions before
operating or servicing the case sealer.
Allow only properly trained and quali ed
personnel to operate and service this
equipment.
• To reduce the risk associated with
pinches, entanglement and hazardous
voltage:
Turn electrical supply o and disconnect
before performing any adjustments,
maintenance or servicing the machine or
taping heads.
component wear and over-heating
of drive motors. The dust build up
is best removed from the machine
with a vacuum cleaner. Depending
on the number of cartons processed,
this cleaning should be done weekly.
Excessive build-up that cannot be
removed by vacuuming should be
removed with a damp cloth.
Quali cation
1
1
2
2
2
2 See Manual 2 or 3
2
Quali cation 2
Should tape adhesive build-up
occur, carefully wipe clean with
oily cloth or brush. Oil prevents
the build-up of tape adhesive
(See Manual 2 or 3)
WARNING
Sections
13.4
13.5
13.6
13.7
13.7-13.8
13.10
NA - ENG
March 2017