3M -Matic 7000a Pro Instructions And Parts List page 144

@5B1D9?>
(continued)
- Keep hands and ngers away from
It is recommended that the detailed
instructions and sketches in this manual
be referred to the rst few times the
taping head is loaded/threaded until the
operator becomes thoroughly familiar
with the tape loading operation.
Note – Remove tape roll before removing
$1@5 ?149>7
1. Place the upper taping head in a
2. Use 97EB5C and tape thread-
3. Attach the threading needle to the
4. Continue pulling the threading needle
5. Pull threading needle down until tape
6. Cut away any excess tape.
Important – Do not cut against apply
$1@5 ?149>7
1. Remove the lower taping head from
2. Lower taping head is loaded and
3M-Matic ™ Accuglide 3 - 3 Inch Taping Head
Page 10
'"  
$? B54E35 D85 B9C; 1CC?391D54 G9D8
C81B@ 2<145 81J1B4C
tape cuto blades under orange blade
guards. The blades are extremely sharp.
taping head from machine to minimize
weight.
%@@5B $1@9>7 514
convenient working position.
ing label. Position tape roll so adhesive
side of tape faces front of taping head
as it's pulled from supply roll.
end of the roll. Guide the threading
needle around the wrap roller
(Position 1) then back around the
one-way tension roller (Position 2).
down and guide it between the two
rollers on the apply arm (Position 3).
travels between apply plate and ears
of apply arm (Position 4) until extends
past apply roller. When threaded adhe-
sive side of tape should face knurled
rollers at position 2 and also position 3.
roller - roller damage could occur.
?G5B $1@9>7 514
the conveyor bed or associated
equipment and place it a convenient
working position.
threaded in same manner as upper head.
'"  
$? B54E35 D85 B9C; 1CC?391D54 G9D8
C851B @9>38 1>4 5>D1>7<5=5>D 81J1B4C
- Turn air and electrical supplies o
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running
%$
$? B54E35 D85 B9C; 1CC?391D54 G9D8
=EC3<5 CDB19>
Use proper body mechanics when
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift
$? B54E35 D85 B9C; 1CC?391D54 G9D8
9=@13D 81J1B4C
Place the taping head on a smooth
level surface when maintaining or
servicing this equipment
97EB5
Insert threading needle through rollers in
direction indicated by arrows.
2
97EB5 $1@5 ?149>7 $8B5149>7
>5 '1I
$5>C9?>
"?<<5B
$5>C9?>
1
'B1@
"?<<5B
>EB<54
"?<<5B
'B1@
3
"?<<5B
@@<I9>7
"?<<5B
4
NA - ENG
April 2017