3M -Matic 7000a Pro Instructions And Parts List page 38

11. Set-Up and Adjustments
Figure 11-4
11.5 Special Set-Up Procedure for Outer Column Re-Positioning (continued on next page)
3M-Matic ™ 7000a-7000a3 Pro
Page 26
B
Moving the outer columns will increase/decrease the maximum box height capacity of the
7000a-7000a3 Pro case sealer.
1. Place solid blocks approximately 12" [305mm] high at front and rear of upper taping
head assembly as shown in Figure 11-7A.
2. Crank the upper taping head assembly down until it touches these blocks.
3. Loosen (but do not remove) the four (4) screws and washers that fasten each column to
the frame (Figure 11-7B).
Note: You may also need to loosen the two set screws in the nut plate bracket
(located above bottom two column screws).
A
(continued)
A
B
Figure 11-5
Figure 11-6
(continued on next page)
Note:
Loosen
but do not
Remove
Column
Screws
Figure 11-7
March 2017
NA - ENG