3M -Matic 7000a Pro Instructions And Parts List page 39

11. Set-Up and Adjustments
11.5 Special Set-Up Procedure for Outer Column Re-Positioning (continued)
Figure 11-8
3M-Matic ™ 7000a-7000a3 Pro
Page 27
(continued)
4. Turn the height adjustment crank clockwise to raise the outer columns until
they reach the stop.
Note: Instructions are indicated for the Standard Column Position (Also see speci cations).
If Alternate Column positions are needed, loosen and re-position the column stop.
5. Tighten the eight (8) screws and washers in each column. Also tighten two (2) Set
Screws (if applicable). Crank upper taping head assembly up and remove blocks.
Moving the outer columns will increase or decrease the box height handled by the
7000a-7000a3 Pro case sealer.
Maximum Height:
An additional adjustment can be made to reach Maximum Height. This additional height
adjustment can be made by moving the Upper Assembly Crossbar up to the top holes -
(Figure 11-8).
NA - ENG
March 2017