3M -Matic 7000a Pro Instructions And Parts List page 150

4:ECD=5>DC
$1@5 57 5>7D8
5149>7 $1@5 57 5>7D8 4:ECD=5>D
97EB5
The one-way tension roller position is
adjustable to control the leading tape
leg length.
Moving this roller farther away from
the box top or bottom surface will
decrease the leading leg length.
Moving it closer to the box top or
bottom surface will increase the
leading leg length.
81>79>7 $1@5 57 5>7D8 6B?=
Note – When changing tape leg length,
1. Remove and retain two hex head
2. Remount and secure brush in posi-
3. Remove cut-o bracket extensions
4. Remount cut-o bracket extensions
5. Remove/retain one-way tension roller
6. Remount tension roller assembly
7. Adjust tension roller according to
- Turn air and electrical supplies o
- Never attempt to work on the taping
3M-Matic ™ Accuglide 3 - 3 Inch Taping Head
Page 16
(continued)
>385C- – 97EB5
== +
both upper and lower heads must be
adjusted to apply same leg lengths.
screws and remove the brush from
normal position "A" on side frame.
tion "A-A" on side frame forward of
normal location with original fasteners.
from position "B".
in forward position "B-B".
assembly from slot "C" in frame.
near top of slot "C-C" in frame using
original fasteners.
"Leading Tape Leg Length Adjustment"
above.
'"  
$? B54E35 D85 B9C; 1CC?391D54 G9D8
C851B @9>38 1>4 5>D1>7<5=5>D 81J1B4C
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
head or load tape while the box drive
system is running
D?
$1@5 57
+ ?B 9>
97EB5
?C9D9?> 
?C9D9?>  
?C9D9?> 
?C9D9?>  
BEC8
97EB5
$? B54E35 D85 B9C; 1CC?391D54 G9D8
C81B@ 2<145 81J1B4C
- Keep hands and ngers away from tape
cuto blades under orange blade guards.
The blades are extremely sharp.
>5 '1I
$5>C9?>
"?<<5B
?B == ==
9>
5149>7 $1@5 57 5>7D8
ED B13;5D
HD5>C9?>
81>79>7 $1@5 57 5>7D8
'"  
#<?D  
#<?D 
NA - ENG
April 2017