3M -Matic 7000a Pro Instructions And Parts List page 142

>CD1<<1D9?>
- Keep hands and ngers away from
"5359F9>7 >4 1>4<9>7
After the taping head assembly has
been unpackaged, examine the unit
for damage that might have occurred
during transit. If damage is evident,
the transportation company and also
notify your 3M Representative.
>CD1<<1D9?> E945<9>5C
The taping head assembly can be
used in converting existing or in
custom made machinery.
It can be mounted for top taping
or bottom taping. Refer to "Box Size
Capacities," as well as 97EB5
in the Speci cations section, for
following points making installations:
Important – Always conduct a hazard
1. The box conveying system
Use proper body mechanics when
3M-Matic ™ Accuglide 3 - 3 Inch Taping Head
Page 8
'"  
$? B54E35 D85 B9C; 1CC?391D54 G9D8
C81B@ 2<145 81J1B4C
tape cuto blades under orange blade
guards. The blades are extremely sharp.
le a damage claim immediately with
review to determine appropriate
guarding requirements when the
installation is in an application
other than 3M-Matic
must positively propel the box in
a continuous motion, not exceeding
0.50 m/s [100 feet per minute],
past the taping head assembly
since the box motion actuates
the taping mechanism.
%$
$? B54E35 D85 B9C; 1CC?391D54 G9D8
=EC3<5 CDB19>
removing or installing taping heads
that are moderately heavy or may be
considered awkward to lift
2. If a pusher/cleated conveyor is used,
3. 97EB5 illustrates the typical
Note – AccuGlide™ 3 High Speed Upper
4. Mounting studs are provided with the
5. Box hold-down/guide skis should be
$1@5 57 5>7D8
Taping heads are factory set to apply
standard 70mm [2-3/4 inch] tape legs.
The heads can be converted to apply
equipment
50mm [2 inch] tape legs if but both upper
and lower heads must be set to apply the
same tape leg length. See "Adjustments –
Changing Tape Leg Length from 70 to
50mm [2-3/4 to 2 Inches]."
Also, conveyor speed at which the
product moves through taping heads
a ects the leading and trailing tape leg
length. See "Adjustments section -
Leading Tape Leg Length Adjustment."
$1@5 '94D8 4:ECD=5>D
Taping heads are factory set to apply
76mm [3 inch] wide tape. If it is
necessary to align the tape or to apply
narrower tapes, refer to "Adjustments –
Tape Web Alignment" set-up procedure.
steps should be taken in conveyor to
prevent pusher from contacting apply-
ing or bu ng roller arms (resulting in
damage to taping head).
mounting relationship for oppos-
ing taping head assemblies to
allow taping of box heights
down to 90mm [3-1/2 inches].
To tape box heights down to
70mm [2-3/4 inches], the taping
heads must be completely
staggered so only one tape seal
is being applied at one time.
Taping Head is supplied with a bu ng
arm guard. Adjustments to guard may
be required to install taping head into
some older design case sealers.
taping head, but special installations
may require alternate mounting means.
provided and taping head mounted so
that side plates are 6mm [1/4 inch]
maximum away from the ski surface on
which the box rides.
NA - ENG
April 2017