3M -Matic 7000a Pro Instructions And Parts List page 147

19>D5>1>35
<51>9>7
Regular slotted containers produce a
great deal of dust and paper chips
when conveyed through taping
heads. If this dust is allowed to
build-up on the heads, it can cause
wear on the moving parts.
Excessive dirt build-up should be
wiped o with a damp cloth.
Cleaning should be done once per
month, depending on the number
and type of boxes used. If the boxes
used are dirty, or if the environment
in which the heads operate is dusty,
cleaning on a more frequent basis
may be necessary.
Note – Never attempt to remove
@@<I9>7 E >7 "?<<5B
"5@<135=5>D
Replacing roller requires removal
of shaft and mounting screws.
With no area on the shaft to grip,
the shaft often turns when attempt-
ing to remove the second screw.
To ease removal of second screw,
a 5mm hex socket has been
provided at the bottom of the
threads in both ends of the shaft.
Insert a 4mm hex key wrench into
this socket after removing one
screw to hold the shaft for removal
of the second screw.
See 97EB5
3M-Matic ™ Accuglide 3 - 3 Inch Taping Head
Page 13
(continued)
dirt from taping heads by
blowing it out with
compressed air.
This can cause the dirt to
be blown inside components
onto sliding surfaces. Dirt in
these areas can cause serious
equipment damage.
Never wash down or subject
taping heads to conditions
causing moisture condens-
ation on components.
Serious equipment damage
could result.
'"  
$? B54E35 D85 B9C; 1CC?391D54 G9D8
C851B @9>38 1>4 5>D1>7<5=5>D 81J1B4C
- Turn air and electrical supplies o
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running
'"  
$? B54E35 D85 B9C; 1CC?391D54 G9D8
C81B@ 2<145 81J1B4C
- Keep hands and ngers away from
tape cuto blades under orange blade
guards. The blades are extremely sharp.
== 5H
5I 'B5>38
97EB5 "?<<5B #816D #53D9?> &95G
5H #?3;5D
#53D9?> &95G ?6
"?<<5B #816D
NA - ENG
April 2017