Install Radiator Core - Hudson Eight 1930 Service & Operating Manual

Remove hood. Drain cooling system. Remove nuts from bolts which. hold radiator to frame cross member.
Loosen upper and lower hose clamps. Unscrew radiator tie rods from radiator shell. Remove shutter control
at radiator. Loosen headlamp connections from terminal block. Lift off radiator. Remove nuts which hold
shell to, core. Remove core. REPLACE radiator core. Replace nuts which hold shell. Replace radiator
assembly on car. Connect radiator tie rods. Replace hose connections. Connect shutter control. Replace hood.
Line up radiator shell with hood. Tighten radiator support bolts. Connect wires to terminal block. Refill
cooling system.
Remarks:

INSTALL RADIATOR CORE

INSTALL RADIATOR CORE
ADJUSTMENTS
Tighten radiator anchor bolts so that rubber mount-
ing shims are compressed 1/32".
There should be at least 1/8" clearance at front edge
of hood.
Suggestions: Rubber mounting pad should be placed against radiator strap; and steel spacer next to frame
cross member. Be sure that bottom edge of lacing ledge on shell does not rest on fender apron. There should
be 3/16" clearance at this point. A piece of rubber hose of 3/8" inside diameter and 28" long will facilitate
draining radiator. Free up and lubricate shutters before assembling.
WWW.PlandeGraissage.ORG WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
86
GREAT EIGHT
GREAT EIGHT
SPECIAL TOOLS
HUDSON
HUDSON