Remove toe and floor boards. Disconnect foot brake pull rod from pedal. Disconnect speedometer shaft.
Disconnect propeller shaft. Remove control hand lever assembly. Disconnect clutch throwout yoke. Remove
pedal control assembly. Remove flywheel guard. Remove transmission assembly. REPLACE transmission
assembly. Replace flywheel guard. Replace pedal control assembly. Connect throwout yoke. Replace hand
control lever assembly. Connect propeller shaft. Connect speedometer shaft Connect foot brake pull rod.
Replace toe and floor boards. Lubricate transmission.
Remarks:
INSTALL TRANSMISSION ASSEMBLY
INSTALL TRANSMISSION ASSEMBLY
ADJUSTMENTS
Mainshaft end play-.006" to .009"
Transmission oil capacity—2 lbs.
Clutch lubrica.nt—1/8 pint motor oil
1/8 pint kerosene
Suggestions: Transmission lubricant should be fluid gear oil. Repack clutch throwout bearing with fiber
grease. Too much oil may cause the clutch to slip. Too much kerosene may cause the clutch to "grab." Relieve
weight from mainshaft drive year when removing transmission.
WWW.PlandeGraissage.ORG
WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
259
GREAT EIGHT
GREAT EIGHT
SPECIAL TOOLS
HUDSON
HUDSON