Install Oil Reservoir - Hudson Eight 1930 Service & Operating Manual

Raise front end of car. Remove oil pan drain plug and drain oil. Disconnect oil gauge wire. Remove oil pan
cap bolts and lower oil pan. Lift out oil pan tray: Remove oil gauge unit fastening screws and remove unit:
REPLACE oil gauge unit and gasket. Replace gauge unit screws. Replace oil pan tray, being sure that gasket
is in place. Replace upper gasket. Put three pints of oil in oil pan troughs. Replace oil pan assembly. Replace
oil pan bolts and tighten evenly. Connect oil gauge. wire. Replace drain plug. Lower car. Put eight quarts of
oil in reservoir.

INSTALL OIL RESERVOIR

INSTALL OIL RESERVOIR
ADJUSTMENTS
Oil pan capacity: Reservoir only, 8
quarts.
Oil pan capacity: Reservoir and
troughs, 9-1/2 quarts.
Suggestions: Be sure that rear main bearing return pipe is not obstructed. Test oil gauge to see that it
functions properly. Tighten oil. pan bolts evenly, to avoid oil leak at gasket.
WWW.PlandeGraissage.ORG WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
153
GREAT EIGHT
GREAT EIGHT
SPECIAL TOOLS
HUDSON
HUDSON