Install Splash Guard (Side) - Hudson Eight 1930 Service & Operating Manual

Remove screws holding rear fender to rear and side splash guards. Remove fender to running board bolts.
Loosen rear fender clamps. Remove rear fender. Remove screws holding running board to side splash guard.
Remove running board to front fender bolts. Remove running board bolt nuts. Remove running board.
Remove screws which hold splash guard to frame and front fender. Remove rear hood lock. Remove body
bolts on one side. Raise this side of body clear of splash guard. Slide splash guard back and out. Remove
splash guard. REPLACE splash guard. Lower body. Replace running board and bolt to fender. Replace rear
fender. Tighten fender clamps. Replace screws which secure splash guard to running board, fenders and
frame. Replace hood lock. Replace body bolts and tighten securely. Touch up bolt and screw heads.
Remarks:.

INSTALL SPLASH GUARD (Side)

INSTALL SPLASH GUARD (Side)
ADJUSTMENTS
Suggestions: Use care in aligning running board with front and rear fenders. If splash guard and screws are
rusted, cut off with cold chisel and replace with new screws. Touch up bolt and screw heads with air dry
enamel.
WWW.PlandeGraissage.ORG WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
184
SPECIAL TOOLS
h—259 Body bolt wrench
HUDSON
GREAT EIGHT
HUDSON
GREAT EIGHT