Remove front compartment mat. Remove toe and floor board. Disconnect foot brake pull rod. Remove
adjustable link clevis pin and disconnect throw-out yoke. Disconnect speedometer shaft. Disconnect propeller
shaft. Remove transmission assembly. Remove clutch throw-out assembly. Remove clutch cover cap screws.
Remove clutch assembly. Remove clutch driving plate. REPLACE driving plate. Replace clutch assembly.
Replace transmission. Replace fly wheel guard. Replace transmission control assembly. Connect propeller
shaft. Connect speedometer shaft. Connect throw-out yoke. Replace adjustable link clevis pin. Connect foot
brake pull rod. Replace toe and floor board. Replace mat. Replenish oil in clutch.
INSTALL CLUTCH DRIVING PLATE
INSTALL CLUTCH DRIVING PLATE
ADJUSTMENTS
Clutch pedal—3/4" clearance between pedal and floor-
board.
Clutch lubricant—1/8 pint motor oil,
1/8 pint kerosene
Suggestions: Dip cork disc assembly in motor oil before installing. Repack throw-out bearing with fibre
grease. Too much lubricating oil may cause the clutch to slip. Too much kerosene may cause the clutch to grab.
Check clutch surfaces on flywheel and pressure plate. Check for warped pressure plate. Use new
clutch cover gasket.
WWW.PlandeGraissage.ORG
WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
67
SPECIAL TOOLS
HE-279 Clutch plate aligning tool
HE-328 Clutch drain plug wrench
HUDSON
GREAT EIGHT
HUDSON
GREAT EIGHT