Install Gasoline Tank - Hudson Eight 1930 Service & Operating Manual

Remove terminal plug from tail lamp socket, and remove tail lamp wires. Remove two bolts holding front
end of trunk rack to frame (Roadster, Coupe and 7-Passenger Sedan excepted). Remove four bolts holding
rear bumper and trunk rack support to frame. Remove bumper, trunk rack, and support assembly. Remove
two bolts holding dust shield to frame. Remove screws and nuts holding dust shield to rear fenders. Remove
two rear body bolts. Remove dust shield. Disconnect gasoline line and gasoline gauge wire. Loosen gasoline
strap hangers and slide gasoline tank down to the left and out of frame. Remove gasoline tank fittings and
install on new tank. REPLACE gasoline tank in frame and tighten strap hanger bolts. Connect gasoline line
and gauge wire. Replace dust shield. Replace body bolts and bolts holding dust shield to frame. Replace
screws and nuts holding dust shield to rear fenders. Replace bumper and trunk rack support and bolt into
position. Replace trunk rack. Replace tail lamp wires and connect to tail lamp.

INSTALL GASOLINE TANK

INSTALL GASOLINE TANK
ADJUSTMENTS
Gasoline tank capacity; 16 gallons.
Suggestions: Test gasoline gauge before and after filling tank. The reserve fuel at zero gauge reading is
21-1/8 gallons. Be sure gasoline pipe and gauge wire connections are tight.
WWW.PlandeGraissage.ORG WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
194
GREAT EIGHT
GREAT EIGHT
SPECIAL TOOLS
HUDSON
HUDSON