Unlatch hood locks. Raise one side of hood. Remove bolt holding rear. hood support to dash. Raise rear end
of hood and slide back. Remove hood. Remove rear hood support from hinge rod and replace on new hood.
REPLACE hood, inserting front end of hinge rod in radiator shell. Replace rear hood support bolt. Close
hood and latch hood locks.
Remarks:
INSTALL HOOD ASSEMBLY
INSTALL HOOD ASSEMBLY
ADJUSTMENTS
Suggestions: Carefully align hood with cowl and radiator to insure correct fit. A small amount of grease
on the hood lacing will prevent squeak at this point. Lubricate hood ventilator door locks.
WWW.PlandeGraissage.ORG
WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
181
GREAT EIGHT
GREAT EIGHT
SPECIAL TOOLS
HUDSON
HUDSON