Replenish Oil In Shock Absorbers (Wahl) - Hudson Eight 1930 Service & Operating Manual

Disconnect shock absorber tie rod at axle anchor. Remove filler hole plug and gasket, using care to
prevent dirt entering hole. Add oil through filler hole, at the same time working arm, up and down. If arm has
a. free center, continue, adding oil and working arm until this condition disappears. Add oil until instrument
is full. Clean and replace filler hole plug and gasket, using a new gasket if necessary to get a tight seat.
Connect tie rod. Check adjustment of rubbers. Repeat this operation on other shock absorbers.
Remarks:

REPLENISH OIL IN SHOCK ABSORBERS (WAHL)

REPLENISH OIL IN SHOCK ABSORBERS (WAHL)
ADJUSTMENTS
Compress upper tie rod rubbers so over-all dis-
tance of rubbers and' washers is 2-1/8".
Compress lower tie rod rubbers to 1-11/16"
over-all dimensions of rubbers and washers.
The eye-bolt in front axle should be square with
tie rod, to insure proper seating of tie rod rubbers.
Oil: Use Wahl Hydraulic Fluid only.
Suggestions: Be sure the bolts holding instrument to frame are tight. Check the following points for
leakage: Rear cover plate, filler hole plugs body cylinder end caps, end plug, rocker shaft.
WWW.PlandeGraissage.ORG WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
222
GREAT EIGHT
GREAT EIGHT
SPECIAL TOOLS
HUDSON
HUDSON