Install Clutch Throw-Out Yoke - Hudson Eight 1930 Service & Operating Manual

PROCEDURE OF OPERATION
Remove front compartment mat. Remove toe and floor boards. Disconnect foot brake pull rod. Remove
adjustable link clevis pin and disconnect throw-out yoke. Disconnect speedometer shaft at transmission,
Disconnect propeller shaft, front end. Remove flywheel guard:. Remove transmission assembly. Remove
throw-out yoke pivot bolt. Remove throw-out yoke. REPLACE throw-out yoke. Replace pivot bolt. Replace
transmission assembly. Replace flywheel guard. Connect propeller shaft. Connect speedometer shaft. Con-
nect adjustable link to throw-out. Connect brake rod. Replace toe and floor boards. Replace mat. Test clutch
pedal adjustment.
Remarks:

INSTALL CLUTCH throw-out YOKE

INSTALL CLUTCH throw-out YOKE
ADJUSTMENTS
Clutch pedal—3/4" clearance between pedal and
toe board when pedal is in normal position.
Suggestions: It is as cheap and more satisfactory to replace throw-out yoke instead of re-bushing the
old yoke.
WWW.PlandeGraissage.ORG WWW.PlandeGraissage.ORG
SPECIAL TOOLS
72
HUDSON
GREAT EIGHT
HUDSON
GREAT EIGHT