Install Dust Shield (Rear) - Hudson Eight 1930 Service & Operating Manual

Remove terminal plug from tail lamp socket. Remove tail light wires. Remove two bolts holding' front of
trunk rack to frame (Roadster, Coupe, and 7-Passenger Sedan excepted). Remove four bolts which hold Tear
bumper and trunk rack support member to frame. Remove bumper, trunk rack and support member assembly.
Remove two bolts holding dust shield to frame. Remove machine screws and nuts holding dust shield to rear
fenders. Remove two rear body bolts. Remove dust shield. REPLACE dust shield. Replace body bolts, Bolt
dust shield to frame. Replace fender to dust shield screws and nuts. Replace bumper, trunk rack and support
member assembly and bolt to frame. Bolt trunk rack to frame. Replace tail light wires. Replace tail lamp
terminal plug.
Remarks:

INSTALL DUST SHIELD (REAR)

INSTALL DUST SHIELD (REAR)
ADJUSTMENTS
Suggestions: Use two shims—part number 87759—between rear dust shield and body brackets to prevent
squeaks at this point.
WWW.PlandeGraissage.ORG WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
178
GREAT EIGHT
GREAT EIGHT
SPECIAL TOOLS
HUDSON
HUDSON