Remove front compartment mat. Remove toe and floor boards. Disconnect foot brake pull rod. Remove
adjustable link clevis pin, and disconnect throw-out yoke. Disconnect speedometer shaft. Disconnect
propeller shaft. Remove transmission control assembly. Remove transmission. Remove clutch throw-out
assembly, Dissemble clutch throw-out assembly. Remove thrust bearing. REPLACE thrust bearing.
Assemble throw-out assembly. Replace throw-out assembly. Replace transmission assembly. Replace
transmission control assembly. Connect propeller shaft. Connect speedometer shaft. Connect throw-out
yoke. Replace adjustable link clevis pin. Connect foot brake pull rod. Replace toe and floor boards.
Replace mat.
Remarks:
INSTALL CLUTCH THROWOUT BEARING
INSTALL CLUTCH THROWOUT BEARING
ADJUSTMENTS
Clutch pedal—3/4" clearance between pedal and
toe-board.
Suggestions: Repack throw-out bearing with fibre grease.
WWW.PlandeGraissage.ORG
WWW.PlandeGraissage.ORG
PROCEDURE OF OPERATION
71
GREAT EIGHT
GREAT EIGHT
SPECIAL TOOLS
HUDSON
HUDSON