Powering On Loads; Setting Parameters For Optional Components; Setting Bcb Parameters - Huawei UPS5000-H-600 User Manual

UPS5000-H-600 kVA-FTN
User Manual (Singapore, 100 kVA Power Modules)
Step 2 Click the Advanced tab, check that Use TLS 1.2 and Use TLS 1.3 are selected, and
click OK.
Step 3 In the address box of the browser, enter https://
Step 4 Enter the correct user name and password and click Login.
Step 5 On the WebUI, choose Monitoring > UPS System > Running Control, click Inv.
ON, and confirm the operation to start the inverter.
----End

5.1.4 Powering On Loads

Context
After the inverter starts, the UPS transfers to inverter mode, and the Bypass mode
alarm on the MDU disappears.
Procedure
Step 1 After confirming that the battery string is properly connected, turn on the battery
string input switch. If there are multiple battery strings, turn on the switch for
each battery string and then the general switch between the battery strings and
the UPS. The No battery alarm on the MDU disappears.
Step 2 Turn on the downstream output switch to supply power to loads.
----End

5.1.5 Setting Parameters for Optional Components

5.1.5.1 Setting BCB Parameters

Prerequisites
A BCB box is installed.
Procedure
Step 1 Choose System Info > Settings > Dry Contact Set, set MUE05A connection to
Enable, and set BCB connection [OL] and Battery breaker [STA] to Enable.
Issue 02 (2023-11-07)
NO TE
If the power module receives a startup command when it cannot be started, the startup
command will be retained for 1 minute. Within 1 minute, if there is no situation (for
example, the power module encounters other faults, executes a shutdown command, or a
fault is rectified) that requires the startup command to be cleared and the power module
becomes able to start, then the power module responds to the startup command.
Copyright © Huawei Digital Power Technologies Co., Ltd.
5 Single UPS Commissioning
UPS IP address .
122