Lenovo 3633 Installation And Service Manual page 154

Figure 80. 3.5-inch hot-swap hard-disk-drive backplane removal
Step 6. Disconnect all cables from the hard-disk-drive backplane.
Installing the 3.5-inch hot-swap hard-disk-drive backplane
To install the 3.5-inch hot-swap hard-disk-drive backplane, do the following:
Step 1. Connect cables to the hard-disk-drive backplane.
Step 2. Carefully lower the backplane assembly into the alignment slots in the chassis. Then, close the
retention latches to secure the backplane to the chassis.
Figure 81. 3.5-inch hot-swap hard-disk-drive backplane installation
Lenovo System x3250 M6 Installation and Service Guide
140