Lenovo 3633 Installation And Service Manual page 132

Figure 50. RAID adapter battery or flash power module installation
Note: The positioning of the remote battery or flash power module depends on the type of the
remote batteries or flash power modules that you install.
Step 8. Complete the parts replacement. See
Removing a USB embedded hypervisor flash device
To remove a USB embedded hypervisor flash device, do the following:
Step 1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
Step 2. Remove the server cover. See
Step 3. Remove the air baffle. See
Step 4. Remove the PCI riser-card assembly. See
Step 5. Locate the USB embedded hypervisor flash device connector on the system board. See
board connectors" on page
Step 6. Slide the lock bar on the flash device connector to the unlocked position and pull the USB flash
device out of the connector.
Lenovo System x3250 M6 Installation and Service Guide
118
"Completing the parts replacement" on page
"Removing the server cover" on page
"Removing the air baffle" on page
"Removing the PCI riser-card assembly" on page
21.
168.
92.
93.
96.
"System-