Lenovo 3633 Installation And Service Manual page 466

User Response:
Complete the following steps:
1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or upgraded,
reseat the adapter and any attached cables.
2. Check IBM support site for any applicable service bulletin or UEFI or adapter firmware update that
applies to this error. NOTE: It may be necessary to disable unused option ROMs from UEFI F1 setup
or onecli or using adapter manufacturer utilities so that adapter firmware can be updated.
3. Move the adapter to a different slot. If a slot is not available or error recurs, replace the adapter.
4. If the adapter was moved to a different slot and the error did not recur, verify that this is not a system
limitation. Then replace the system board. Also, if this is not the initial installation and the error
persists after adapter replacement, replace the system board.
• I.2018003: [I.2018003]
[I.2018003]
Severity: Error
User Response:
Complete the following steps:
1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or upgraded,
reseat the adapter and any attached cables.
2. Move the adapter to a different system slot, if available.
3. Check IBM support site for any applicable service bulletin or UEFI or adapter firmware update that
applies to this error. NOTE: It may be necessary to configure slot to Gen1 or to use special utility
software so that adapter firmware can be upgraded. Gen1/Gen2 settings can be configured via F1
Setup -> System Settings -> Devices and I/O Ports -> PCIe Gen1/Gen2/Gen3 Speed Selection, or the
onecli Utility.
4. Replace the adapter.
• I.3818001: [I.3818001]
[I.3818001]
Severity: Info
User Response:
Complete the following steps:
1. Reboot the system. Will come up on backup UEFI image. Update the primary UEFI image.
2. If error does not persist no additional recovery action is required.
3. If error persists, or boot is unsuccessful, replace the system board.
• I.3818002: [I.3818002]
[I.3818002]
Severity: Info
User Response:
Complete the following steps:
1. Update the backup UEFI image.
2. If error does not persist no additional recovery action is required.
3. If error persists, or boot is unsuccessful, replace the system board.
• I.3818003: [I.3818003]
Lenovo System x3250 M6 Installation and Service Guide
452