Lenovo 3633 Installation And Service Manual page 130

Step 7. Reinstall the ServeRAID adapter. See
Step 8. Complete the parts replacement. See
Removing a RAID adapter battery or flash power module
Note: The RAID adapter battery or flash power module is supported on the 2.5-inch-drive server models
only.
To remove a RAID adapter battery or flash power module, do the following:
Step 1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
Step 2. Remove the server cover. See
Step 3. Remove the RAID adapter battery or flash power module.
a. Remove the retainer.
b. Open the retention clip.
c. Pull the release tab outward.
d. Lift the battery or flash power module up to remove the battery or flash power module from the
holder.
Figure 48. RAID adapter battery or flash power module removal
Step 4. Disconnect the cable from the battery or flash power module.
Step 5. Complete the parts replacement. See
Installing a RAID adapter battery or flash power module
When you install any RAID adapter that comes with batteries or flash power modules, sometimes it is
necessary to install the batteries or flash power modules in another location in the server to prevent the
batteries or flash power modules from overheating. Depending on your server model, a battery must be
installed remotely near the optical drive cage or the backplane.
Note: The RAID adapter battery or flash power module is supported on the 2.5-inch-drive server models
only.
Lenovo System x3250 M6 Installation and Service Guide
116
"Installing an adapter" on page
"Completing the parts replacement" on page
"Removing the server cover" on page
"Completing the parts replacement" on page
112.
168.
92.
168.