Lenovo 3633 Installation And Service Manual page 134

Figure 52. USB embedded hypervisor flash device installation
Step 7. Complete the parts replacement. See
Removing the front I/O assembly
The front I/O assembly contains an operator information panel and two cables.
To remove the front I/O assembly, do the following:
Step 1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
Step 2. Remove the server cover. See
Step 3. Disconnect the USB cable and the operator information panel cable from the system board.
• To release the USB cable connector, press the release latch
connector. Then, pull out and disengage the USB cable connector from the USB connector on
the system board.
• To release the operator information panel cable connector, press the release latches
sides of the cable connector. Then, pull out and disengage the cable connector from the
operator information panel connector on the system board.
Lenovo System x3250 M6 Installation and Service Guide
120
"Completing the parts replacement" on page
"Removing the server cover" on page
168.
92.
on the top of the USB cable
1
on both
2