Lenovo 3633 Installation And Service Manual page 44

Select this choice to view or reset the IMM2.1 to the default settings.
– Reset IMM2.1
Select this choice to reset the IMM2.1.
– Recovery and RAS
Select this choice to view or change the POST attempts and system recovery settings.
– Backup Bank Management
Select this choice to view or change the backup bank management setting.
– Disk GPT Recovery
Select this choice to view or change the Disk GPT recovery options.
– POST Attempts
Select this choice to view or change the number of attempts to POST.
• POST Attempts Limit
Select this choice to view or change the Nx boot failure parameters.
– System Recovery
Select this choice to view or change system recovery settings.
• POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
• POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
• Reboot System on NMI
Select this choice to enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. The default setting is Enable.
– Storage
Select this choice to view or change the storage device settings.
– Network
Select this choice to view or change the network device options, such as iSCSI.
– Drive Health
Select this choice to view the status of the controllers installed in the blade server.
• Date and Time (available on the full Setup Utility menu only)
Select this choice to set the date and time in the server, in 24-hour format (hour:minute:second).
• Start Options (available on the full Setup Utility menu only)
Select this choice to view or change the start options, including the startup sequence, PXE boot option,
and PCI device boot priority. Changes in the startup options take effect when you start the server.
The startup sequence specifies the order in which the server checks devices to find a boot record. The
server starts from the first boot record that it finds. If the server has Wake on LAN hardware and software
and the operating system supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that checks for a disc in the CD-
RW/DVD drive, then checks the hard disk drive, and then checks a Ethernet controller.
• Boot Manager
Lenovo System x3250 M6 Installation and Service Guide
30