Lenovo 3633 Installation And Service Manual page 124

Figure 39. Optical drive filler installation
Step 7. Complete the parts replacement. See
Step 8. Reinstall the security bezel. See
Installing the optical drive
The following tips describe the type of optical drives that the server supports and other information that you
must consider when you install an optical drive. For a list of supported optical drives, go to:
http://www.lenovo.com/ serverproven/
• Locate the documentation that comes with the optical drive and follow those instructions in addition to the
instructions in this topic.
• Make sure that you have all the cables and other equipment specified in the documentation that comes
with the optical drive.
• The server supports one ultra-slim SATA optical drive.
To install the optical drive, do the following:
Step 1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
Step 2. Remove the security bezel. See
Step 3. Remove the server cover. See
Step 4. Remove the optical drive filler.
Step 5. Connect the optical drive cable. Make sure that the cable is not pinched and does not cover any
connectors or obstruct any components on the system board.
a. Align the cable connector with the connector bracket on the chassis, insert the cable
connector into the bracket, and slide it to the left until it is firmly seated.
b. Connect the other end of the cable to the system board.
Lenovo System x3250 M6 Installation and Service Guide
110
"Completing the parts replacement" on page
"Installing the security bezel" on page
"Removing the security bezel" on page
"Removing the server cover" on page
168.
95.
95.
92.