Lenovo 3633 Installation And Service Manual page 112

Figure 24. PCI riser-card assembly installation
Step 4. Complete the parts replacement. See
Removing the flash power module holder
Note: The flash power module holder is supported on the 2.5-inch-drive server models only.
To remove the flash power module holder, do the following:
Step 1. Turn off the server. Then, disconnect all external cables and remove all peripheral devices.
Step 2. Remove the server cover. See
Step 3. Remove the flash power module. See
on page 116.
Step 4. Remove the two screws that secure the holder and then remove the holder.
Figure 25. Flash power module holder removal
Lenovo System x3250 M6 Installation and Service Guide
98
"Completing the parts replacement" on page
"Removing the server cover" on page
"Removing a RAID adapter battery or flash power module"
168.
92.