Figure 105. Simple-swap HDD cable connection: 2.5-inch, onboard RAID, and hot-swap power supply
Hot-swap HDD cable connection: ServeRAID SAS/SATA controller and fixed power
supply
•
: Connect to the backplane power connector on the system board and the power connector on the
1
hard-disk-drive backplane.
•
: Connect to the connector 0 on the ServeRAID SAS/SATA controller and the Mini-SAS connector on the
2
hard-disk-drive backplane.
Notes:
• Ensure that the cable is not pinched and does not cover any connectors or obstruct any components on
the system board.
• Ensure the relevant cables pass through the cable clips.
Lenovo System x3250 M6 Installation and Service Guide
160