Lenovo 3633 Installation And Service Manual page 168

Note: When you are holding or installing the system board in the server, avoid touching the cable
clips on the side of the chassis and the connectors on the system board. Do not damage any
surrounding components inside the chassis.
Step 2. Hold the two corners
with the corresponding mounting studs on the chassis, and then install the nine screws that you
removed.
Figure 97. System board installation
Step 3. Install any of the following components that you removed from the failing system board:
Note: Make sure that none of the server cables are caught under the system board.
1. Microprocessor and heat sink (see
technician only)" on page
2. DIMMs (see
3. Adapters (see
4. The RAID battery holder (see
Step 4. Complete the parts replacement. See
Step 5. Remove the microprocessor socket cover from the new system board and install it onto the failing
system board.
Step 6. Start the Setup Utility and reset the configuration.
a. Set the system date and time.
b. Set the power-on password.
c. Reconfigure the server.
For more information, see
Step 7. Either update the server with the latest RAID firmware or restore the pre-existing firmware from a
CD image. See
Step 8. Update the UUID. See
Lenovo System x3250 M6 Installation and Service Guide
154
of the system board carefully, align the screw holes in the system board
1
145)
"Installing a DIMM" on page
"Installing an adapter" on page
"Installing flash power module holder" on page
"Completing the parts replacement" on page
"Using the Setup Utility program" on page
"Updating the firmware" on page
"Updating the Universal Unique Identifier (UUID)" on page
"Installing the microprocessor and heat sink (Trained
102)
112)
25.
99).
168.
27.
39.