Table of Contents
Advertisement
Used to connect the signal cable for the RDX tape drive or the SD module.
22
Clear CMOS jumper
Used to clear CMOS and turn the BIOS settings into the factory default settings.
Note: Clearing CMOS does not erase your BIOS passwords.
To clear CMOS, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See "Preparing your server in advance and removing the server cover" on
page 49.
3. Lay the server on its side for easier operation.
4. Locate the Clear CMOS jumper on the system board.
5. Move the Clear CMOS jumper from the default normal position (pin 1 and pin 2) to the short-circuited
position (pin 2 and pin 3).
6. Reconnect the server to an ac power source and turn on the server. Then, wait more than 10 seconds.
7. When you hear beeps, turn off the server. Then, move the Clear CMOS jumper back to the normal
position (pin 1 and pin 2).
8. Reinstall the server cover and connect the power cords. See "Completing the parts replacement" on
page 111.
9. Connect the server to an ac power source and turn on the server. The clearing CMOS process is
completed.
23
HDD LED connector
Used to connect cable from the HDD status LED on the front panel.
24 25 26 27
PCIe slots
Slot
24
PCIe slot 4
25
PCIe slot 3
26
PCIe slot 2
27
PCIe slot 1
28
Rear system fan connector
Used to connect the rear system fan.
28
Intrusion switch connector
Used to connect the intrusion switch.
30
Coin-cell battery
Your server has a special type of memory that maintains the date, time, and configuration information for
built-in features. The coin-cell battery keeps the information active when you turn off the server.
Physical slot size
x1
x16
x1
x 16
Negotiable link
bandwidth
x1
x4, x1
x1
x8, x4, x1
Supported card length
and height
Full-length, full height
Full-length, full height
Full-length, full height
Full-length, full height
.
Chapter 3
Product overview
31
Advertisement
Table of Contents
