Table of Contents
Advertisement
Figure 37. Removing the drive from the drive tray
8. Install a new non-hot-swap drive or dummy tray to cover the drive bay. See "Installing a non-hot-swap
drive" on page 63.
9. If you are instructed to return the old non-hot-swap drive, follow all packaging instructions and use any
packaging materials that are supplied to you for shipping.
Installing a non-hot-swap drive
To install a non-hot-swap drive, do the following:
1. Prepare your server and remove the server cover. See "Preparing your server in advance and removing
the server cover" on page 49.
2. Use the front door key to unlock the front door (available on some models), and then open the front
door.
3. Remove the front system fan 1. See "Installing the front system fan 1" on page 87.
4. Locate the appropriate non-hot-swap-drive bay. See "Front view of the server" on page 13.
5. Align the holes in the drive tray with the corresponding ones in the new non-hot-swap drive. Then, install
the four screws to secure the drive to the drive tray.
Figure 38. Installing the drive to the drive tray
6. Slide the new non-hot-swap drive into the drive bay until it snaps into position.
.
Chapter 5
Replacing hardware
63
Advertisement
Table of Contents
