Atlas Copco Tensor STB User Manual page 30

Appendix
Figure 31 Found New Hardware Wizard, fifth screen
8. Click to exit the
Finish
Software setup
1. Install the ToolsTalk Service software on the PC by executing the ToolsTalk Service_a_b_c_d.exe
file, where a, b, c and d is the release number.
2. Start the ToolsTalk Service software.
3. In the
Select tool
NOTE: ToolsTalk Service must be restarted and this procedure must be repeated if changing
between angle and pistol tools and vice versa.
4. In the main window, select
5. In the
Select communication
6. In the
Communication
field set to the USB
Port
device that matches the
Tensor STB docking
station.
7. Click .
OK
The docking station is now ready
to use.
30 (36)
Found new Hardware Wizard
window, select
Tensor STB
Options > Settings
window, select
Figure 32 Communication settings in TTS
.
for angle tool or
Tensor STB ETP
.
Tensor STB Docking Station
for pistol tool.
from the drop-down list.
9836 3043 01