Getting Started With Irc-W - Ad Hoc - Atlas Copco Tensor STB User Manual

 PEAP, TKIP
 PEAP, AES/CCMP
 EAP/TLS, WEP128
 EAP/TLS, TKIP
 EAP/TLS, AES/CCMP
 To setup the controller use ToolsTalk Power Focus or Graph interface and do the following settings:
1. Set parameter
2. Set parameter
3.
T293 Power Focus IP port
 Reboot Power Focus.
NOTE: It is possible to run IRC-W infrastructure on an IRC Focus.
Getting started with IRC-W – Ad hoc
3.5.3
This is the default Operation mode for the IRC-W tool. If this setting has been changed, tool must be re-
programmed to ad-hoc, see 3.8Connecting tool with ToolsTalk Service. The Ad hoc mode makes it
possible to set up on which channel to communicate.
In ToolsTalk Power Focus do the following settings:
1. Set parameter
2. Set parameter
3. Set
T294 Serial port
4. Set parameter
tool will select the best available channel.
5. Reboot Power Focus.
6. Continue to section
9836 3043 01
to
T290 Primary tool IRC-W
T296 IRC-W operational mode
is default
6677
to
T290 Primary tool IRC-W
T296 IRC-W operational mode
to if a Serial Port Adapter is used or
Serial 2
to the correct channel number. If Auto is selected the PF and the
T297 IRC-W channel
3.6 Connecting tool with Power Focus (Pairing)
.
to .
Infrastructure
, and must be the same as in the tool.
.
to .
Ad-Hoc
for IRC Focus.
Internal
.
System setup
13 (36)