Table of Contents
Advertisement
17.2.8
Network status display (NetSTAT)
Press and hold the [UP]+[DOWN]+[ENTER] configuration buttons for at least 10 seconds (only in the LAN mode) to open the
synoptic screen of the network seen from the user terminal in question. The screen exemplifies the status of the LAN, showing
how many and what devices are connected, and with which address.
Press [UP] and [DOWN] to view the firmware version resident in the terminal.
To exit the NetSTAT screen, press [ENTER].
17.3 Settings on the user terminal
In the presence of units connected to a local LAN network, indicate the total number of connected unit on the Priority unit, then,
if needed, enable the functions provided by the LAN. The functions are as follows:
•
regulation based on the temperature and humidity average value read by all network units;
•
presence of backup units that rotate and are possibly ready to intervene in the presence of extreme ambient
temperature and humidity conditions.
The configuration parameters for the LAN network are under the "LAN" menu, which can be accessed by entering the
"Service" password.
These are visible on all connected units in the same group.
More specifically, the settable parameters are:
•
Number of units connected to the local LAN network;
•
enabling average calculation functions in LAN;
•
enable the backup unit and its rotation;
•
Interval of time between one rotation and the next (in other words: stand-by time
•
number of backup units;
•
enable the start function for the backup units when exceeding the room temperature and humidity limits;
•
definition of units belonging to the same group;
•
definition of Priority units;
•
definition of forced Priority units;
Version 38
193
Advertisement
Table of Contents
