Table of Contents
Advertisement
INFORMATION:
If no key is pressed for a few seconds, the display will exit the configuration screen. In this case, the
procedure must be repeated.
17.2.6
Addressing of the user terminal
Once the keyboard has been connected to the device, run the following procedure.
1)
Press and hold [UP]+[DOWN]+[ENTER] at the same time for at least 3 seconds to enter
configuration mode. A mask is displayed with the cursor flashing in the top left corner.
2)
Press [ENTER] once to modify the address of the terminal (display address setting). The
cursor will move to the terminal address field. Press [UP] or [DOWN] to select the value of
the desired address and then press [ENTER] again to confirm.
The value will be saved in the permanent memory of the terminal.
3)
The appearance of the mask shown at the side indicates that the keyboard address has
been set.
If an empty mask or a mask showing "NO LINK" appears after pressing [ESC], it means
4)
that the keyboard is not communicating with any boards. The addressing of the controller
board, the configuration of the terminals associated with the board or the configuration of
the LAN local area network must be performed.
INFORMATION:
If no key is pressed for a few seconds, the display will exit the configuration screen. In this case, the
procedure must be repeated.
17.2.7
Configuration of the terminals associated with the board
1)
Press and hold [UP]+[DOWN]+[ENTER] at the same time for at least 3 seconds to enter
configuration mode. A mask is displayed with the cursor flashing in the top left corner.
2)
Press [ENTER] twice to modify the address of the board to be configured.
The cursor will move on the board address field. Press [UP] or [DOWN] to select the value
of the board address to be configured and then press [ENTER] again to confirm.
3)
The access mask for configuration of the associated terminals appears. Press [ENTER] to
continue.
4)
The address of the board being configured appears in the top left of the mask shown
alongside for configuration of the associated terminals. The three lower lines permit
association of up to three terminals, the addresses of which must be set in the second
column of each line. It is possible to establish whether the terminal is private (Pr) or shared
(Sh) in the third column.
Press [UP] and [DOWN] to change the value of the parameter selected with the cursor, and
[ENTER] to move the cursor.
With the cursor on the "No" variable next to "Ok?", press [ENTER] again to make any
further changes, otherwise press [UP] to change the value to "Yes", and press [ENTER] to
save the changes and exit the mask.
The values are saved in the permanent memory of the controller.
INFORMATION:
If no key is pressed for a few seconds, the display will exit the configuration screen. In this case, the
procedure must be repeated.
Version 38
Display address
Setting..........: 00
Display address
Setting..........: 21
I/O Board address: --
Display Address
changed
NO LINK
Display address
Setting..........: 11
I/O Board address: --
Display address
Setting..........: 11
I/O Board address: --
Terminal config
Press ENTER
to continue
P:01 Adr Priv/Shared
Trm1 11
Pr
Trm2 32
Sh
Trm3 None
-- Ok?No
192
Advertisement
Table of Contents
