Mitsubishi Electric Evolution+ s-MEXT Technical Manual page 19

The "Factory" password is managed using the Service software, which for each controller configures a password, which is
then saved in the job. The password is only available to the after-sales service.
Once at the last digit of the password, by pressing the [ENTER] key the software will compare the entered password with those
stored in its memory. If the password entered is incorrect, the "Wrong Password" message is displayed for a few seconds. All
the fields are cleared and the cursor moves back to the first entry position to the left.
To go back with the cursor to the previous password digit, just press the [ESC] key. It is then possible to return to the menu
selection.
To change the "User" password access the "Info" menu inside the "User" group and scroll the masks until the "User"
password change mask appears.
The window to change the "Service" password, which can be accessed by entering the "Settings" menu, under the "Service"
group.
The window to change the "Factory" password can be accessed from the "Config" menu", under the "Factory" group.
OBLIGATION:
If the "Factory" password is changed, remember to re-enter the password generated by the
service software at the end of the test, after maintenance is completed.
INFORMATION:
The parameters in the menus of the "Factory" group can only be changed after switching off
the unit (fan OFF).
Version 38
"User" Password
1234
(modifiable)
"Service" Password
9990
(modifiable)
"Factory" Password
0000009982
(modifiable)
Info - Pwd change
Insert a new
User password:
0000
19