Mx1601B-R Pin Assignments - HBM SomatXR MX Series User Manual

Connector
pin side of cable
45

4.3.1 MX1601B-R pin assignments

Connect sensors via the 14-pin ODU MINI-SNAP connectors.
Pin Connection
1 --
2 --
3 Voltage input (+), IEPE (+)
4 Signal ground
jumper to pin 5
5 Ground cable detect
jumper to pin 4
6 Current input 20 mA (+)
7 --
8 --
9 Active sensor supply (-)
10 Active sensor supply (+)
11 --
12 --
13 TEDS (-)
14 TEDS (+)
Shield Shield
NOTE
Connection between pins 4 and 5 is necessary for all transducers. Note that the
sensor connector must have a connection between pins 1 and 11 for
compatibility with the MX1615B-R module.
The adjustable transducer excitation between 5 and 24 volts is only available on
channels 1 through 8. These channels can draw a maximum of 0.7 W per channel or
2 W total.
Channels 9 through 16 output the supply voltage (10 ... 30 V) minus approximately
one volt. A maximum current of 30 mA per channel or 75 mA total can be consumed.
The current limitation switches the transducer excitation off if current consumption is
higher.
A4089-5.0 en HBM:Public.
Wire color
(1-KAB183 or 1-KAB184)
Black
Blue
White/Black
Red/Black
Pink/Black
Yellow/Black
White
Red
Brown
Yellow
Grey
Green
Grey/Black
Green/Black
--
MX Modules