Setting Up A System; Getting Started With The Mx Module - HBM SomatXR MX Series User Manual

2 Setting Up a System

MX Modules

2.1 Getting started with the MX module

To set up a CX23-R controlled system, refer to
R. Otherwise, proceed to get started using the following information.
Each MX module has a similar back panel with a power connector, two FireWire
connectors, and one Ethernet connector.
To get started, connect a DC voltage source of 10 to 30 volts (24 recommended) to
the X104 power supply port using the 1-NTX002 AC/DC power supply unit or the 1-
KAB294-5 power supply cable. Connect the host PC to the Ethernet (X100) or
FireWire (X101 or X102) ports of the module using the 1-KAB273-5 Ethernet cable or
1-KAB293-5 FireWire cable, respectively.
For more information on connecting the module to a host PC, see
single module to host PC
A4089-5.0 en HBM:Public.
Connecting MX modules to a CX23-
and Connecting multiple modules to host
2 Setting Up a System
Connecting a
PC.
17