Outputs; Output Measurement Signals To Can Bus; Mx840B-R - HBM SomatXR MX Series User Manual

6 Outputs

MX Modules

6.1 Output measurement signals to CAN bus

6.1.1 MX840B-R

The MX840B-R Universal Amplifier
(channel 1). This mode is configured entirely in the
6.1.2 MX 471B-R
The MX471B-R CAN Module
in real time, to be output to the CAN bus. This gateway mode is typically used in test
benches or in mobile measuring mode, for connection to a central CAN-based data
logger.
This mode is configured entirely in the
must be parameterized isochronously (in real time), and then assigned to the relevant
CAN port. The parameterization is permanently stored in the modules (EEPROM).
To simplify integration at the opposite end (e.g. logger/test bench), the MX Assistant
can generate a CAN database of signals (.dbc).
6.2 Output signals in real time
6.2.1 MX878B
The QuantumX MX878B Analog Output Module allows for up to eight analog voltage
outputs for measured sensor values and channel calculations in real time. This mode
is configured using the
Assistant software. All other MX modules must be connected via FireWire, and the
signals to be transmitted must be parameterized isochcronously (in real time) and
then assigned to the relevant analog voltage output. The parameterization is
permanently stored in the modules (EEPROM). The maximum measuring rate is
limited to 5 kHz. The mapping of harmonic signals up to approximately 500 Hz is
excellent.
A4089-5.0 en HBM:Public.
allows channels 2-8 to output to the CAN bus
allows measurement signals, or the signal calculated
MX Assistant. The signals to be transmitted
CX23-R Data Processor
MX Assistant.
or using the catman®AP
6 Outputs
or MX
82