Get Device Configuration - ICP DAS USA I-7532RM-FD Service And Usage Information

Hide thumbs Also See for I-7532RM-FD:

Table of Contents

3.3.1.

Get Device Configuration

Press the "Refresh" button to scan and list all the necessary I-7532RM-FD modules

on "Module Name" location.

NOTE:

The module name for the I-7532M-FD and I-7532RM-FD on the utility will appear as

"I-7532-FD".

Then select the necessary I-7532RM-FD module and press "Get Device Config."

button to start to connect and get device configuration.

[Get Device Config.]

This button is used to get all configuration from module. After get the module's

configuration, all the module's parameters will be listed in "CAN", "Filter", "Mapping

Rule", "Merging Rule" and "Splitting Rule" fields.

[Config. Device]

This button is used to set all the settings, listed in "CAN", "Filter", "Mapping Rule",

"Merging Rule" and "Splitting Rule" fields, to module.

[Load Config. From File]

This button is used to get all configuration from a selected file. After load the module's

configuration from a file, all the module's parameters will be listed in "CAN", "Filter",

"Mapping Rule", "Merging Rule" and "Splitting Rule" fields.

[Save Config. To File]

This button is used to save all the parameter settings, listed in "CAN", "Filter", "Mapping

Rule", "Merging Rule" and "Splitting Rule" fields, to a selected file.

I-7532RM-FD ( 2-port CAN/CAN FD Bridge )

User Manual (version 1.0.0)

Page: 22

Table of Contents