Table of Contents
Advertisement
Chapter 4: System Setup
Installing a SO-DIMM
1. Push the ejector tabs which are at the ends of the socket outward. Then
insert the module into the socket at an approximately 30 degrees angle.
Apply firm even pressure to each end of the module until it slips down
into the socket. The contact fingers on the edge of the module will
almost completely disappear inside the socket.
Copyright © 2015 NEXCOM International Co., Ltd. All Rights Reserved.
Ejector tab
34
VTC 6210-R Series User Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the VTC 6210-R Series and is the answer not in the manual?
Questions and answers