Iscsi Offload; Uefi Mode - NEC Express5800 Series Maintenance Manual
Hide thumbs
Also See for Express5800 Series:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 2 Useful Features
10.2
iSCSI Offload
This section describes how to enable iSCSI Offload feature.
10.2.1 UEFI Mode
1. Power on the server.
2. On the POST screen or after NEC logo is displayed, press <F2> key to run BIOS Setup Utility.
3. Select Advanced PCI Device Controller and Option ROM Settings.
4. Put the cursor onto LAN1 Option ROM Scan or LAN2 Option ROM Scan, and select Enabled.
5. Save the BIOS settings, and restart the server.
6. Press <F2> key again to launch SETUP utility.
Select Advanced UEFI Driver Configuration.
7. Select Broadcom NetXtreme II 10Gb Ethernet BCM57810 you want to configure.
142
Note
This feature is available only when N8403-083F 10GbE (2ch) riser card is installed.
With N8403-081F or N8403-082F installed, this feature is not available.
If Option ROM Scan for LAN1 and LAN2 are set to Disabled, the screen as shown in step
Tip
6 will not be displayed.
Express5800/B120f-h Maintenance Guide
10. Advanced LAN Configuration
Advertisement
Table of Contents
