NEC Express5800 Series Maintenance Manual page 165

Chapter 3 Appendix
Error Message
C120 BMC Runtime FW corrupted.
BMC Force Update FW corrupted. Failed to start BMC FW.
C121
C122 BMC Configuration area
corrupted.
C123 BMC eMMC inaccessible.
C125 BMC eMMC mode error.
BMC eMMC partition corrupted. An error occurred on partition of
C126
C127 BMC eMMC format corrupted.
C128 BMC is in Update Mode.
C200 The error occurred during memory
configuration check.
C300 Out-of-band setup
configuration failure
C301 SDR mismatch error.
Hardware configuration error. Detected that hardware
C302
C310 Hardware configuration of
cooling is insufficient.
C320 Unmatched PSUs.
C321 System power consumption is
out-of-range in PSUs.
C322 No information for system
power consumption check.
C400 Can't Read FRU on CPU Unit
TypeI Mezzanine
C401 Can't Read FRU on CPU Unit
TypeII Mezzanine
C501 ME is in Recovery Mode.
Cause
Failed to start BMC FW.
An error occurred on BMC
Configuration area.
Initialization failed due to an access
error occurred in internal flash
memory of BMC.
A mode error occurred in internal
flash memory of BMC.
internal flash memory of BMC.
A format error occurred in internal
flash memory of BMC.
BMC is in firmware update mode.
Memory configuration check error
was detected.
An error was detected while
accessing BMC Mezzanine card.
Inconsistency in the hardware
information of the sensor data
record was detected.
configuration of the server is illegal.
Detected that cooling power is
insufficient in this hardware
configuration.
Detected that unmatched power
supply units are configured.
Detected that system power
consumption exceeds the power
output capacity limit.
Detected that no information was
acquired in checking system power
consumption.
Cannot read Mezzanine Slot1 FRU.
Cannot read Mezzanine Slot2 FRU.
Intel Node Manager is in Recovery
Mode.
Express5800/B120f-h Maintenance Guide
1. Error Message of POST and Virtual LCD
Solution
Power off the CPU blade, remove it from
blade enclosure, wait for at least 30
seconds, and then install it again.
Contact your sales representative.
Power off the CPU blade, remove it from
blade enclosure, wait for at least 30
seconds, and then install it again.
Contact your sales representative.
Turn off the power, wait for at least 30
seconds, check the power supply units, and
restart the server.
Contact your sales representative.
Power off the CPU blade, remove it from
blade enclosure, wait for at least 30
seconds, and then install it again.
165