Usage Of System Diagnostics - NEC Express5800 Series Maintenance Manual

Chapter 1 Maintenance
8.2

Usage of System Diagnostics

After turning off the server or restarting the server, run System Diagnostics as follows.
1. Run EXPRESSBUILDER and choose Tool menu from Boot Selection Menu.
See Chapter 2 (5. Details of EXPRESSBUILDER) for details.
2. Choose Test and diagnostics.
3. Choose End-User Mode (Basic) to run System Diagnostics.
This process takes about three minutes.
When the diagnostics is completed, the screen changes as shown below.
See eupro_ug_en.pdf in the \isolinux\diag folder of EXPRESSBUILDER for the End-User Mode
(Professional) feature.
Supervisor-Mode is intended for maintenance personnel.
Diagnostics tool title
Diagnostics tool title
Shows the name and version of the diagnostics tool.
Test window title
Shows the progress of the diagnostics. "Test End" appears when the diagnostics completes.
Test results
Shows the start, end, and elapsed time and completion status of the diagnostics.
Guideline
Shows the details of the keys to operate window.
Test summary window
Shows the results of each test. Move the cursor and press <Enter> key on the cursor line to display the
details of the test.
If an error is detected by System Diagnostics, the relevant test result in the Test summary window is
highlighted in red, and "Abnormal End" appears in the result on the right side.
Note
Choose English if Language selection menu appears.
Press <Y> key if "Hit key to continue. [y|Y]" appears in Redirection mode.
Guideline
Express5800/B120f-h Maintenance Guide
8. System Diagnostics
Test window title
Test results
Test summary
window
43