Table of Contents
Advertisement
Chapter 2 Useful Features
11.2
iSCSI Offload
This section describes how to enable iSCSI Offload feature.
11.2.1
UEFI Mode
1. Power on the server.
2. On the POST screen or after NEC logo is displayed, press <F2> key to run BIOS Setup Utility.
3. Select Advanced → PCI Device Controller and Option ROM Settings.
4. Put the cursor onto LAN1 Option ROM Scan or LAN2 Option ROM Scan, and select Enabled.
5. Save the BIOS settings, and restart the server.
6. Press <F2> key again to launch SETUP utility.
7. Select Advanced → UEFI Driver Configuration.
8. Select QLogic 577xx / 578xx 10Gb Ethernet BCM57810 you want to configure.
Note
This feature is available only when N8403-096 10GbE (2ch) riser card is installed.
With N8403-094 or N8403-095 installed, this feature is not available.
If Option ROM Scan for LAN1 and LAN2 are set to Disabled, the screen as shown in step
Tip
6 will not be displayed.
Express5800/B120g-h Maintenance Guide
11. Advanced LAN Configuration
131
Advertisement
Table of Contents
